It's really easy the switch is in the steering colume.
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
Replacing a steering column ignition switch on a 2002 Pontiac Grand Prix is not considered a major repair. The task is considered easy but if done wrong could be dangerous. It is best to refer to vehicle manual for the car to ensure proper direction is given.
i have a 2003 Pontiac grand am, no start, does not even turn over. could it be the ignition switch?
ignition what? coil, swicth,module, lock cylinder? gm Jim
it is located on the steering column
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
how much to insall a ignition to a pontiac grand am se 1999?
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
under the throttle body.
the ign switch or the key & tumbler ???
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
How do you replace starter on2.3 cy 1991 pontiac grand am
Need a little more info on what your trying to replace. Is it the switch in the dash? It's in the overhead console.
how do I replace water pump 2000 Pontiac Grand AM SE1?
Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.
how to replace lifters on a 03 grand am
It's located on the steering column 2 screws unplug the harnest
If it looks the same it will probably work.
first remove the dash trim around the switch. the trim should just pull off. its held in by push clips. next remove the screw that holds the switch, push in on switch a little then wiggle it out. remove the electrical connection from back of switch, then pull switch out. to install is reverse of removal.
My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.
I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.
how do i replace a water hose in 1993 pontiac grand am