0
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
What else can I help you with?
How do you install the ignition switch in a 2004 Pontiac grand am?
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
How do you remove ignition switch 2004 Pontiac Montana?
pull it really hard
How can you Disable the kill switch on a 2004 Pontiac grand am?
To disable a kill switch the wiring would have to be modified to bypass the switch. This is not advisable as the switch is a safety feature.
My 2004 Pontiac grand am wont fire all lights come on but it wont start?
I had the same problem with my Grand Am and there is a recall on the ignition switch. I had to take the vehicle to an authorized GM dealer and they replaced it for me at no cost.
Who won the 2004 Pontiac Grand Prix?
The 2004 Pontiac Grand Prix is not something that is won as it's not a competition of any sorts. The 2004 Pontiac Grand Prix is a car sold by the Pontiac car company.
Pontiac grand am where do you put coolant?
How do i add antifreeze to a pontiac grand am 2004
How do you remove the ignition switch in a 2004 Pontiac Grand Am?
pull trim around radio, speedometer. pull gauges radio and ac controls there is two screws .pull them. then pull electric wires to get releases cable out the key has to be in on position
Were is the shift solenoid located on a 2004 Pontiac grand prix?
Where is the shift solenoid located on a 2004 pontiac grand prix
Does a 2004 Pontiac grand am 3.8 have a timing belt or a chain?
The ( 3.4 liter V6 ) in a 2004 Pontiac Grand Am has a timing CHAIN
Where is the ignition module located in a 2004 Pontiac grand am gt?
In a 2004 Pontiac Grand Am GT, the ignition module is typically located on the front of the engine, mounted to the ignition coil assembly. It is positioned near the top of the engine, close to the intake manifold. To access it, you may need to remove the engine cover and other components that obstruct the view. Always consult the vehicle's service manual for specific instructions and safety precautions when working on the ignition system.
How do you reset tire pressure on a 2004 Pontiac grand prix?
how do you reset the tire pressure warning light on a 2004 pontiac grand prix
How do you replace hazard switch 2004. Pontiac grand am?
To replace the hazard switch on a 2004 Pontiac Grand Am, start by disconnecting the negative battery cable to ensure safety. Remove the trim panel around the radio and climate controls to access the switch. Detach the old hazard switch by pulling it out of the panel and disconnecting the wiring harness, then connect the new switch and reassemble the trim panel. Finally, reconnect the battery and test the new switch to ensure it functions properly.
