buy a haynes manual and follow the instructions
or, follow the exhaust pipes until you find the sensors (there are 2 of them) they screw in and have a thin wire running out of them. follow the wire to the nearest connection, disconnect it and turn the sensor out of the pipe. if it's really rusted, use tons of penetrant - WD 40 or the like. You absolutely don't want the sensor so snap or the threats to get damaged.
Jeep dealer.
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
It is part of the latch inside the door.
You do not fix it you just replace it.
there is a coil on each plug
My 99 Jeep had the same issue, eventually it had No spark, I replaced the engine coil, it didn't work, had to replace ingnition sensor.
yes, the '98 and '99 are identical
no, 99
1993 Jeep Cherokee Ignition Wiring ...
Crank sensor is on the driver side of the bell housing, Cam sensor is in the distributor. Computer is mounted to the inner fender.
No.
Yes