you have to separate the front auger housing fron the back engine and drive housing. there should be several bolts on both sides you have to remove. once the two housings are separated you have to loosen off belt guard pins and pull the belt off. dissemble slowly so you can see how to reassemble
Replace Angus cable craftsman 3.8 snowblower
May possibly be a loose missing or worn belt.
if one shear pin has been sheared then just line up the auger shear pin holes the same as the opposite auger shear pin then tap out damaged pin.
if one shear pin has been sheared then just line up the auger shear pin holes the same as the opposite auger shear pin then tap out damaged pin.
There are repair videos on the link below that will show you how to do it. Just copy and paste in your browser.
possible broken auger belt, or one that has slipped off the pulley
Got a toro 521 wont blow snow after 2 feet whats up
Jewel-Osco.
Be sure that the belt hasn't stretched so it may be slipping. I don't think there is a actual adjustment but rather that it is either cracked or stretched too much to operate the auger properly.
It depends on how it is bent. If it is just the flitting you can use a bar and a hammer. If it is the shaft you might be able to bend it back with a bar. If not you will have to replace it with new or used parts.
That means the auger is the only moving part that throws the snow. Two stage snowblowers have an auger to move the snow to the fast moving impeller.
check for stretched or broken auger belt