0
What else can I help you with?
What does the red brake warning light on a 1989 ford bronco mean?
Either your emergency / parking brake is on or your brake fluid level in the brake master cylinder in your engine compartment is LOW
How do you reset the anti lock brake warning light on a 1989 bronco 2?
Correct the fault which is causing the light to come on and it will go out on it's own.
Where is the pcm located on a 1989 ford bronco?
The PCM for the 89 Bronco is located on the firewall on the driver side. You can access it from inside the cab, behind the parking brake pedal.
How do you replace the left rear brake light bulb on a 1998 Acura Integra hatchback?
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
How do you replace the rear brake shoes on an 1989 Ford Ranger?
Take it to a garage and ask them "Can you replace my brake shoes please"
Honda Accord and brake lamp?
the 1989 Honda accord lxi has a brake lamp light on the dashboard, if the brake lamp light is on, this means you have a brake/tail light out or disconnected
Where is the fuel reset button located on a 1989 ford bronco XLT?
look on the driver side firewall by the brake pedal
Where is the brake light switch on a 1989 Regal?
I believe most brake light switches are located under the dash above the brake pedal.
Why would your brake light be on 1989 mercury marquis?
Brake light switch stuck, defective, or out of adjustment.Brake light switch stuck, defective, or out of adjustment.
Diagram of a 1989 Bronco II Fuse Box?
list of fuses for 1989 bronco 2
How much does it cost replace an exhaust system on a 1989 Ford Bronco XLT?
$ 300 magnaflo sounds same as stock
How do you gain access to the third brake light on a 1989 Corvette Coupe to change the bulbs?
To access the third brake light on a 1989 Corvette Coupe, first, open the rear hatch and remove the plastic cover that protects the light assembly. This typically involves unscrewing or unclipping the cover. Once removed, you can access the bulbs by twisting them out of their sockets. Replace the bulbs as needed and reassemble the cover.
