you need to remove the front wheels then locate and remove the two bolts holding the caliper in place.once you do this you might have to pry on the caliper a little to get it to come off,once it comes off then remove the brake pads one at a time making sure to note which one has the ware sensor on it.once you remove the pads then you will need to squeeze the caliper piston back in, i have found that the easiest way to do this is to use a big"c" clamp.after you get the piston back in then you can put the new pads in. then just do the reverse to put it back together.
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
It's an automatic, there is no clutch.
replace the cam sensor
The throttle position sensor can be removed by dismantling the chassis in which it sits. This can be done by referencing the owner's manual f the Pontiac Montana.
What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6
The 2000 Pontiac Montana does not have a vacuum modulator installed on it. Instead, it has an electronically controlled transaxle.
where is the freeze plug located in a 2000 pontiac montana mini van
No
r134a
my 2000 Montana is still on its original fuel pump
You need to replace the rear wheel hub - bearing and speed sensor inclusive
they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana