Vehicle make, model & engine size needed first.
12 bucks Autozone
The coolant temperature sensor, on a 2005 Ford escape, can be changed by loosening the sensor retaining nut. Once the knot is removed the sensor will pull out.
It means it's time to replace the coolant temperature sensor.
coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.
Where is the coolant temperature sensor on a 2001 ford focus?" Where is the coolant temperature sensor on a 2001 ford focus Where is the coolant temperature sensor on a 2002 ford focus
engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty.
It is located under the coolant reservoir. You can't just replace the sensor. The whole coolant reservoir must be replace. It's a simply 10 minute job.
The engine coolant temperature sensor is usually on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.
how do you replace coolant temp sensor on a rodeo
NOTE: this answer is describing the location of the engine coolant temperature sensor - NOT the coolant sensor in the reservoir that warns when the level gets too low.The coolant temperature sensor is located directly adjacent to the thermostat housing. The thermostat housing is what the upper radiator hose (toward the right side of the engine compartment) connects to. You do not have to replace the reservoir to replace this part, but leaky coolant reservoirs are a common problem on this model.
Well, honey, the coolant temperature sensor on a 1995 Toyota Tercel is usually located near the thermostat housing or on the cylinder head. To replace it, first, make sure the engine is cool, then disconnect the electrical connector, unscrew the sensor using a wrench, apply some thread sealant on the new sensor, and install it in the same location. Don't forget to reconnect the electrical connector and refill the coolant if needed. Good luck, darling!
You could look here:http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlThis page shows the coolant sensor and how to replace it.'95 Subbie and '97 should be similar.