answersLogoWhite

0


Best Answer

under vechile near rear of engine going in from engine side toward transmission there is a 2 wire sensor with 1 bolt holding it in.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace crank position sensor Jaguar XJ8?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a crank position sensor on a 2001 Mitsubishi galant?

Where is the crank position sensor 0n a 2001 mitsubishi Galant


Where is the crank position sensor located on a 1993 Infinity G20?

trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor


Where is the crank position sensor for a 95 blazer?

Where is the crank position sensor hole on a 2003 Blazer


How do you change crankshaft position sensor?

where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace


How do you repair the crank signal so that the engine will continue to run?

replace cam position sensor


How you replace a crank position sensor 1997 BMW 528i?

Bmw 528 1997 not start


How do you replace a crank position sensor in a hummer h2?

its behind the starter, disconnect the battery to begin with!


Is the throttle position sensor and crank position sensor the same thing?

No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.


What is the location of the crank position sensor on a 1990 Firebird 3.1?

it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap


1994 s10 blazer crank position sensor?

The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.


How do you change the crank position sensor on 1996 buick?

Actually, you don't replace the sensor itself. The crazy thing is part of the harmonic balancer, and you have to replace the whole thing.


Bad crank position sensor?

Crank no start.