0
What else can I help you with?
Where is the crank position sensor on a 1994 S10 blazer with a vortex motor?
That truck still has a distributor, it doesn't have a crank position sensor.
Does a 1994 Buick Skylark have a throttle position sensor or a crank sensor?
It has both.
Will crank position sensor interfer with ignition module on a 1994 jeep Cherokee?
The ignition module uses the crank sensor to decide when to spark.
Where is the crankshaft position sensor located on a 1994 Toyota Corolla 1.8L?
where is the crank sensor for 1994 toyota corolla 1.6 ltr
Where is the crankshaft position sensor and the camshaft position sensor located on a 1994 Ford Thunderbird 4.6L?
the crank shaft position sensor should be behind A/C compressor.
Where is the Location of the crank position sensor for 1994 Corsica 3.1?
its locted by the crank pulley the ower pully on the car
On a 1994 ford ranger the crank position sensor it brakes the magnet off the sensor and there is not enough adjustment to stop it how can you stop that?
On a 4.0 V-6 the crank position sensor is in a fixed location and cannot come in contact with the crank if it is installed correctly.
Where is the crankshaft position sensor in a 1994 Corvette?
1994 corvette quit accepting more and more throttle then died and wont crank
Where is the crank position sensor on a 1994 Chrysler new yorker?
It is on the passenger side of the transmission bell housing.
Where is the crank position sensor in a 1995 olds delta 88?
on a 1994 it's behind the harmonic balancer
How do you change a crank position sensor in a 1994 buick regal?
To change the crank position sensor in a 1994 Buick Regal, first disconnect the negative battery cable to ensure safety. Locate the crank position sensor, which is typically found near the crankshaft pulley or on the engine block. Remove the sensor's electrical connector and unscrew the mounting bolt to take out the old sensor. Install the new sensor by reversing the removal steps, ensuring it's securely fastened, and reconnect the battery.
Where is the crankshaft position sensor on 1994 mercury sable 3.8 L V 6?
I cant remember if a 1994 had a distributer or not. If it has a distributer, there is no crankshaft position sensor. That information is a calculated value using the input from the distributer stator(pickup coil). If there is no distributer, then there will be a crank sensor on the front of the engine down by the crank pulley.
