0
in the passenger foot compartment, the duct work for your heater is above the passengers feet, under the dash. there is a harness plugged into a resistor (fan speed) that is held in the plastic duct by 2 screws. unplug the resistor, unscrew the 2 screws, your old resistor will come right out. put the new resistor up in its place, put the screws back in, the plug the harness back in. takes about 20 minutes.
What else can I help you with?
You only have high speed on your heater blower what is wrong 2003 mercury sable?
The most likely problem with the heater blower on your 2003 Sable is the blower resister. The resister can go bad and cause you to only have one speed.
Where is the high speed resister on my 2003 winstar blower motor?
It would have a high speed relay and it would be in the power distribution box under the hood. The blower speed resister is for the lower speeds only.
How do you replace the cabin air filter on a dodge Dakota 2003?
A 2003 Dodge Dakota does not have a cabin filter.
Where is the air conditioning fan switch and resister located in a 2003 dodge Dakota?
first of all nice.and umm have you tried the website?
Replace the serpentine belt on a 2003 Dodge Dakota?
The serpentine belt on a 2003 Dodge Dakota is replaced by loosening the belt tensioner and slipping the belt off. It can then be removed from the engine accessories and a new belt installed.
Why does the heating resister on a 2003 Dodge Dakota over heats and burns the plug?
The blower motor if failing and pulling to much current.The blower motor if failing and pulling to much current.
Location of blower motor resister on 2003 Chrysler town and country?
Well, In the 2002, the blower motor resister is behind the glove copartment. You might want to check there.
How do you replace PCV valve on 2003 dodge Dakota?
go to the local auto shop and tell them you ned your pcv valve replaced
How do you replace the headlight Bulbs on 2003 Dodge Dakota?
To replace the headlight bulbs on a 2003 Dodge Dakota, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the bulb, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, taking care not to touch the glass with your fingers, and reassemble by reversing the steps. Finally, test the headlights to ensure they are working properly.
Where is the speed sensors located on a 2003 g m c Yukon?
Speed o meter stop working need to replace speed sensor. Need to fine the location of sensor on a G M C Yukon 2003
Why does the heater fan only works on high on a 2003 Chrysler town and country?
YOUR BLOWER RESISTER IS BAD
When was Ritz Dakota Digital created?
Ritz Dakota Digital was created in 2003.
