Remove two bolts from lower control arm and one nut from frame located in center of upper control arm, which may need just bent back and forth a few times and broken if severely rusted.
Yes.
== ==
Yes, the crossmember for suspension is in front of the engine. Very easy job.
it will most likely be easier to just replace the pump all at once
Will a 1976 Corvette C3 Hood fit on a 1978 Corvette C3.
Remove all the screws, take the arm rest off, and lift.
Use your door key in the front drivers side fender keyhole
stick the key in the driver front fender and turn.
Driver side front of the engine. Just follow the fuel line from the carb down to it.
1976 top will not work on an 81' The latches are different.
The "StingRay" designation was dropped from the Corvette after 1976.
It is possible to replace the rear body mounts on a 1976 Corvette without completely removing the body, but it can be a challenging and time-consuming task. You may need to partially lift the body off the frame to access and replace the mounts. Having the right tools and equipment can make the job easier and safer.