unbolt the engine mount on that side and raise the engine to get it off.
Replace the power steering pump.
It's built into the power steering reservoir. To replace it you need to replace the whole reservoir. Fortunately, this is an inexpensive part... ($30).
Take it to a garage.
It will take approximately 1.5 hours to replace the power steering pump in your 2000 Dodge Durango. The exact amount of time will depend upon the person that is doing the repair.
around 111.75
Since There is no tensioner pulley you have to loosen your alternator.
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
What have to do replace the belts water pump power steering
Power Steering fluid helps to keep the steering of a car running smoothly. A Dodge Caravan uses Mopar ATF +4 for power steering fluid.
To add power steering fluid to a Dodge 350, locate the power steering reservoir, which is typically situated near the front of the engine bay, often on the driver's side. The reservoir usually has a cap labeled "Power Steering" for easy identification. Remove the cap and add the appropriate type of power steering fluid as specified in your owner's manual, ensuring not to overfill. Replace the cap securely after adding the fluid.
To replace the power steering unit on a 2001 Dodge Dakota, first, disconnect the negative battery terminal and drain the power steering fluid. Remove the serpentine belt and disconnect the power steering pump from its mounting brackets, along with the hoses attached to it. After removing the old pump, install the new one by reconnecting the hoses and securing it in place, then refill the power steering fluid and bleed the system to remove any air. Finally, reattach the serpentine belt and reconnect the battery.
1996 dodge ram 5.9 power steering pully removal?