real easy open the hood ,on top of the light are 2 screws 7MM on is about 1" long the other 5" long remove both screws now gently pull the light assembly out by lifting the bottom out side and pulling forward , it will take a little wiggling but it will come out. then remove the black collar around the light by turning loose the ring ,now pull the bulb strait out note how it is sitting in the hole. next do not touch the glass on the new bulb you skin oil will cause it to burn out much faster, insert bulb and reinstall in reverse order ,making sure the assembly is in so the long screw gos through the hole in the bottom on the light assembly tighten bolts and turn on lights TEST !your done .
Charge it, test it, replace it.
100,000 miles
Yes
100,000 miles
The windshield washer pump on a Chrysler Sebring convertible is replaced by disconnecting the wiring harness and unbolting the pump. It can then be lifted from its mounting bracket and a new pump put into place.
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
It is not a direct swap. They use different transmissions, computers, wiring, etc.
6 hours
Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
It will bolt up, but I do not think you will have the power electrical connector.
Yes. The fuel tank must be removed to access the pump.
A 2001 Chrysler Sebring does not have a cabin filter.