answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace heater hoses in a 2000 VW Beetle TDI?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix heater core in 2000 new beetle?

In order to probably repair the heater core in your 2000 New Beetle, you will probably have to get the entire heater core replaced.


What makes the 2000 marquis ac blower stop working?

replace the blower motor resistor. it is located on the firewall near the heater hoses.


No heat on your 2000 dodge neon. We just replace the radiator and thermostat. We also replace the upper and lower hoses. Both hoses are getting hot but still no heat?

Check the heater hoses on the right side of the engine. If one hose is hot and the other is not , you might have a blocked heater core. Or the blend door actuator might not be operating correctly.


Where is the heating core on a 2000 mercury ls?

Follow the heater hoses from the engine. They will lead right to the heater core.


Why does heater in a 2000 Dodge Neon only blow cold air?

you may not have the heater water hoses plugged in


How do you change Audi 4000 heater core?

Remove the water supply hoses from your heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.


How do you bypass heater core on 2000 ford expedition?

just splice the two heater hoses that go through to the heater core the together


Where to purchase heater hoses for 2000 Silverado 1500 4 WD?

Dealer item.


How do you replace heater core in 2000 Pontiac grand prix?

where is the heater core at


How do you replace heater core in a 2000 Pontiac grand prix?

where is the heater core at


Does it hurt to swap inlet and outlet hoses on heater core in a 2000 Chevy blazer?

No it will not, it will just back flush the heater core and clean it out.


How do you replace the rear heater hoses that hold coolant in a 2000 Dodge grand caravan?

I cut off the rusted out lines with a small tubing cutter and replaced them with regular heater hose and clamped the ends. Copper tubing and hose clamps also work.