Want this question answered?
how do you replace the drive belts on an 1974 mercedes 230
Ignition wiring diagram
30 degrees on dwell or 16 thousands with feeler gauge (close)
go to library and get a chiltons manual for 74 Chrysler products.
First unhook the battery. Then put the key in (you need it!) and turn it to "on." Remove the steering wheel and the ignition switch just slides out.
You'd have to describe the components you replaced. Did you use a plug and go all in one distributor or did you replace the coil, distributor, and add an electronic ignition unit? If you "fried" your ignition, it's likely you fried something else along the line too. Check all your components.
Ford was making the switch to electronic ignition on the 300 straight 6 during the production of the 1974 model year Ford truck
the ignition module is in front of the lft front wheel,inside the fender. the module wiring harness runs thrue a hole /gromet in the fender into the engine compartment just in front of te ignition coil.
The dash mounted ignition switch is spring loaded. The face is held on by two hooks and stubs.. It is removed by reaching up behind the dash and pressing the back of the switch towards the dash, then turn the face of the switch counter clockwise to release..
Mercedes Sahores was born in 1974.
Mercedes Molto was born on February 21, 1974, in Barcelona, Catalonia, Spain.
very very simple wiring---it goes from the ignition switch to the fuse box--then directly to the voltage regulater and then straight to the starter solenoid