answersLogoWhite

0


Best Answer

you go to a mechanic

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace intake manifold gaskets on a Dodge 318?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is your dodge magnum leaking oil?

Usually when you leak oil that's an indication that the intake manifold gaskets need to be replaced or your intake manifold is shot.


How hard is it to replace head gaskets on 2002 dodge ram?

You must remove the intake manifold, disconnect the exhaust manifolds, and then remove the heads. This is a major repair that takes skill and knowledge. Unless you know what you are doing this repair is best left to a professional.


Should you clean or replace the Intake Manifold on a 2008 Dodge Avenger 2.4 engine?

Need to know what the diagnoses or symptoms are.


Can you replace a 2 barrel carb on a 1966 440 dodge to a 4 barrel?

yes you can but you will have to get a 4bbl. intake manifold and install it.


Can you put a Dodge 5.2 intake manifold on a 3.9 Dodge engine?

No.


Where is the temp sensor on Dodge Dakota?

On the intake manifold


Do you need new gaskets when you replace your dodge rams transmission?

Yes, always replace gaskets on any projects requiring them.


Wher is the intake manifold runner control valve on a 2008 Dodge Avenger?

Finding the intake manifold runner control on a Dodge Avenger is easy. It is located near the engine.


Where is the check valve to heater control on a 1998 dodge ram 1500?

Passenger side of the intake manifold.Passenger side of the intake manifold.


Does a 1994 dodge ram 1500 have an egr valve?

Yes, back of intake manifold.Yes, back of intake manifold.


What goes wrong with 2007 dodge charger When your short runner valve go bad?

Normal cause is the intake manifold itself.Normal cause is the intake manifold itself.


Where is the oil pressure switch located on a 07 dodge caliber?

Under the intake manifold, near the end of the starter.Under the intake manifold, near the end of the starter.