With a socket for removing plugs. The wires should just slip off and need to be replaced with the exact same length.
I would replace the spark plugs after 50K, the wires and plugs again at 100K.
No you do not need to replace any plugs at all when replacing wires.
If you gap all the new plugs first and then replace the plugs and wires one at a time you won't have to worry about messing up the firing order. (This will happen if you pull all the plug wires at once and don't replace them in the same locations.)
how to replace spark plugs wires 1992 buick century v 6 3300 stationwagon
Check/replace the spark plugs and wires. If you're not going to replace the plugs make sure the gap is correct (should be either .040 or .060) and make sure the plugs are clean of oil or gas. If it still backfires after you replace the plugs/wires check the distributor and the timing.
If you do not have any problems with plugs, change them when you replace the timing belt (do not forget to replace the spark plug wires too).
Disconnect the battery, remove the spark plugs wires and boots and remove the spark plugs. Put in the spark plugs, replace the spark plug wires and boots, and connect the battery.
Check and replace plugs, wires, cap and rotor.Check belt and tensioner.Check all fluids.Check and replace plugs, wires, cap and rotor.Check belt and tensioner.Check all fluids.
Disconnect the battery, remove the engine cover, remove the spark plugs wires and boots, and remove the spark plugs. Put in the new spark plugs, replace the spark plug wires and boots, replace the engine cover, and connect the battery.
To replace the spark plugs from a 2004 Kia Sedona the plug wires ,must be removed from the engine. Unscrew the plugs. Properly space the new plugs and screw them in.
You have to follow the wires and find the plugs first. Change those with a spark plug wrench that fit's them Replace the plug wires one at a time.
Disconnect the battery, remove the boots and wires, and remove the old spark plugs. Put in the new spark plugs, reattach the boots and wires, and connect the battery.