Want this question answered?
if your under miles its under warrenty
05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
The 2006 Legacy license plate bulb is accessed by removing the liner in the trunk and un screwing the plastic socket.
You do not need to take the fabric off the inside of the trunk. The lamp snaps off if you push one side with a flat screw driver and pull down. http://youtu.be/0KPLYCj_RQM A few images to assist in license plate Bulb replacement.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
how to replace dome light on ford f-450
Yes; pg.43 in the official Florida driver's handbook 2008.
On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it. On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it.
how do you replace side marker light on 2008 chevy trailblazer
To replace a light bulb, you have to: if its in the front, you have to open up the hood and look for the screws that are connected to the lights. For the back, you have to: open the trunk, and unscrew the light bulb, open it up and replace it.
how do you remove dome light lens on 2008 trailblazer