answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2007-05-13 15:43:06
2007-05-13 15:43:06

Should be "peel off" type Remove wheels Remove caliper mounting bolts Slide caliper off rotor Slide rotor off hub

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions



Front or rear rotors and 2 wheel or 4 wheel drive, it makes a difference.


Jack of the rear of your 2001 Oldsmobile Aurora. Remove the tire and wheel. Remove the brake pads and break assembly. Tap on the rotors with a hammer or mallet. Slide the rotors off. Reverse the process to install the new rotors.



We need to know the year, make, model and front or rear rotors to answer that one. also need to know if the rotors and hubs are one piece or separate.



how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you


Remove the rear wheels, then the calipers and simply pull the rotors off. If the parking brakd is on the caliper you need a special tool ot retract the caliper.


What should it cost to replace rear brakes, drums and rotors, '96 Volvo 850 GLT.



Remove the wheel and the four bolts that hold it. Very easy




The 1998 General Motors/GMC Jimmy came equipped in the 4.3L Vortec V6 engine. The removal of the rear rotors is a simple mechanical procedure. The vehicle needs to be safely raised (shop lift or jack stands). The rear wheels/tire assemblies can then be unbolted. After hanging the calipers, which need the brake pistons compressed, they can be put to the side with a hangar off the frame. The rotors should then slide out. If they are proving difficult a small blow with a shop rubber mallet helps to release rotors and drums.


If the truck has disc brakes on the rear then the park brake shoes are located inside the rear rotors. You have to remove the brake calipers, pads and rotors to access them


I recently got a quote for my 2003 Kia Optima brake pads & rotors to be replaced in the rear and it came to $183 before taxes. This price is to replace both pads and rotors completely. Usually rotors don't cost much to be turned.


Depending on the pads, around $150 for front or rear, and depending on the car, around $250 for the rotors.


To change rear rotors on a 2001 Jetta, raise the vehicle with a jack. Then remove the wheel and the calipers. Finally, pull of the rear rotors.?æ?æ


i was wondering how to change rear brake drums for 1999 Chevy venture


I believe the awnser varies on what model you have... I have a 1999 galant GTZ mine has disc ( rotors ) front and back, The rear has the disc drum combo for the parking brake... Hope this helps


i need a diagram on how rear brakes are assembled


Removing Front & Rear Rotors Well Guys... I remove my Front & Rear Rotors out of my 1998 Ford Expedition XLT. I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off... The way I removed the Front & Rear Rotors was ... 1. I put lots of PB Blaster in the back and the front of the rotors to be removed. 2. I put plenty of tension with the 3 Jaw Puller... 3. I hit the back of the rotor with the sledge hammer... And it came right off... Hope this helps someone out there...


When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.





Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.