answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace rear short stabilizer bar on a 98 qx4 infinity?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a rear stabilizer?

its a bar that gose over the suspention and keeps the rear wheels ballenced with each other and the fornt wheels too. i broke my front stabilizer bar jumping and i cost my like 145 to replace it.


How do you replace a stabilizer bar bushing on a 1998 Lincoln Mark VIII?

You didn't mention front or rear, the rear is much easier, the front one is one pain.


How replace rear Sway Bar Bracket Bushing Chevrolet trailblazer 02?

unbolt stabilizer link and replace with new one (be careful, wear proper safety equip. may spring loose, do not lay directly under or over the stabilizer link.


Squeeking noise from my rear left tire when turning?

Some 2001 and 2002 Sonata, XG300 and XG350 vehicles may experience a knocking or squawking noise from the rear suspension while driving the vehicle over rough road surfaces at low speeds. This noise may originate from the rear stabilizer bar and bushing rubbing together. This bulletin provides a procedure to correct this condition.The problem is the rear stabalizer bushing. The new design part number is 55577-38600Lift up the vehicle.Remove the rear stabilizer bracket mounting bolt.Remove the stabilizer bracket from the stabilizer bushing.Remove the stabilizer bushing from the stabilizer bar.Install the new stabilizer bushing after checking the yellow mark.Align the stabilizer-bushing end with the white mark on the stabilizer bar.Install the stabilizer bracket on the bushing and tighten the bracket mounting bolt. Tightening torque: 35-45 Nm (350-450 kg.cm, 26-33 lb.ft)Replace the stabilizer bar bushing on the other side.Lower the vehicle.


Rear wiper from infinity?

Rear wiper for the infinity fx 35 is available only from an infinity dealer.


How do you replace the stabilizer sway bar link to 2003 Ford F150?

How do you install a rear sway bar on a 2003 f 150 4 wheel drive


What is a stablizer bar bushing?

The stabilizer bar rotates on the stabilizer bushings (usually 2 bushings required) be it front or rear of vehicle.


How much labor is involved replacing a car stabilizer?

Depends on the vehicle and if it is the front or rear stabilizer. Most are easy, some are difficult.


How do you replace rear disc pads on infinity i35?

You will need to remove the tire and wheel from your Infinity i35. Remove the disk pad Springs and caliper. The disk pads will come off. Reverse the process to install the new disk pads.


Why would the rear end of a 1999 Cougar clunk with general driving and when going over bumps?

I had a Mercury Cougar with the same sound, I replaced the rear stabilizer/sway bar links. They are reasonable inexpensive and are very easy to replace providing you have some experience with working on suspension.


When turning right you hear a clunk sound?

the stabilizer bars on the rear end usally the bushing s wear out


Front and rear speaker size in 2002 dodge ram quad cab?

Depending on your trim level.... 1in center and 2-3.5s in dash w/infinity factory... Standard 6x9 in front doors, and 5.25 in rear door.. We install alot of infinity 6x9s and infinity 6.5 in these.. You can fit 6.5s in the rear if you drill new screw holes.