answersLogoWhite

0


Best Answer

Did you mean turn signal sockets? Replacements can be bought with pigtail leads that can be spliced in, or OEM replacement parts may have an in-line connector. I haven't replaced any sockets on my Intrigue, so I can't speak from experience. Most of the sockets I have replaced were cracked or heat damaged, and they usually snap in or twist in to the bezel or housing. Be careful to first observe how the socket is mounted as the all-plastic parts on cars can easily break.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace signal sockets in a 2002 Olsmobile Intrigue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a 2000 Oldsmobile Intrigue headlight assembly?

The plastic headlight assembly is held in by two clips. Pull them up to release the assembly. The headlights and turn signal lamps are quarter (90°) twist-in sockets, and also need to be disconnected before you can remove the entire assembly from the car. The bulbs plug into the sockets once they are removed from the assembly.


How do you replace turn signal light on a 2002 Oldsmobile intrigue?

Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.


What if your front turn signals don't work but the rear ones do on your 2000 intrigue?

The sockets for the front turn signal often get too hot and fail on these cars. Bad design. They half melt and have a bad connection.


1999 Ford F-250 Turn signals not working No power to either left or right turn signal fuse What else could it be?

Replace turn signal flasher wiggle your fuses while signal is on--After weeks and lots of $-my fuses were loose in the sockets-had to shim them up with foil=dont replace the fuse box it costs hundreds


Where is the Turn Signal Flasher Control Module on a 1998 Oldsmobile Intrigue?

The 1998 Oldsmobile Intrigue turn signal flasher control module is below the dashboard on the drivers side of the passenger compartment. The signal flasher control module should be labeled as such.


On a 2001 Olds Intrigue how do you get to the rear turn signal bulb to replace it?

remove the wing nuts or nuts and the whole assembly can be removed from the car wing nut removal from inside the trunk


How do you replace rear turn signal bulb on 1995 Corsica?

Open the trunk, look for some plastic nuts, remove these and remove your rear lens assembly; remove sockets from assembly.


Why does the turn signal on your Chevy pick up blow fusses?

You have a dead short somewhere, it could be in one of the the bulb sockets, the wiring or the signal switch.


How you replace the front right turn signal bulb on a 1998 s70 Volvo?

Open the engine hood. look into the area between the headlight and the turning signal. There is a tab on the turning signal. Press the tab and pull the turning light forward, the entire light will come off. Twist the bulb socket and pull to remove, replace the bulb. If you car still takes the 3157 bulb, you need to have the recall done for the new sockets from Volvo.


Left turn signal works right one does not hazard works on jeep?

Assuming you have checked all of the bulbs, sockets and wiring, the signal flasher could be weak or the signal switch is bad.


How do you replace front turn signal on a Oldsmobile 2002 Intrigue?

pull two clips and the entire lens will come out the TS has its own socket that usually burns out and needs to be replaced so far only available at a dreler for about $27


Where is the signal flasher on a 2000 Oldsmobile intrigue?

In the fuse box under the hood. There is a diagram on the lid of the box.