first remove the (3) torx bolts from the back glass then remove the (2) 10 mm bolts from the hinge after that its a snap to change out just unplug the old and plug in the new and repeat the process
hope this helps any do-it-yourselfers out there wanting to upgrade their Yukon/Yukon XL(new body style)
as i make more and more improvements to the wife's Yukon i will lst what was done to maybe assist others in upgrading their own full size SUV
thanks,
Sam
3rd brake light or rear brake lights?
From inside the trunk.
The third brake light on a 2007 Toyota Avalon is replaced by first removing the rear, retaining screws. The wiring harness can then be disconnect and the light bulb removed.
The brake light bulb on a 2007 Cadillac CTS can be replaced by opening the truck, removing the rear cover, and disconnecting the wiring harness. The bulb can then be twisted, removed, and a new bulb put in its place.
You can find the 2007 Nissan brake light fuse in the fuse box. The brake light fuse will be in the second column, third from the top.
how to change brake light switch in a 2007 chevy colorado
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
On my 2007 Sonata I had to replace the brake pads and rotors at 57000 miles.
Open the trunk, directly below the center brake light is the electrical plug and wire for the light. Depress the small tab on the plug that connects to the bulb in the center brake light. Pull the plug out of the connector. Next, release each of the two tabs on each side of the plug. Enter the back seat of the car and remove the brake light housing. Unscrew the bulb holder from the housing by turning it 1/4 turn counter-clockwise. Replace the bulb, replace the bulb holder, replace the housing (back hooks first then snap into place. Replace the plug into the connector. Test. Rejoice (optional). MPC 12/17/2007
how to replace rea pads on 2007 crew cab f150
2007 Hyundai Elantra brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
The Squeal means its time to replace the Brake pads.