answersLogoWhite
Alternators
Nissan Frontier
Nissan Maxima
Rodeo Events

How do you replace the alternator on a 1993 Nissan Maxima V6?

363738

Top Answer
User Avatar
Wiki User
2015-07-15 21:00:37
2015-07-15 21:00:37

Suggest replacing all the belts also. 1st belt, remove coolant res. loosen the pulley next to the res. then there is a tension bolt behind it. get under the car, the alternator is right there on the passenger side. possible under a small shield. loosen all the bolts on the alternator, then there is a tentioner on the alternator. loosen that, remove belt, then take out the rest of the bolts, along with the plug and the ground wire to the alternator. for the P/S belt, loosen the other pulley 14mm, and then the tention bolt is another 12mm.

1

Related Questions

User Avatar

NO/ I JUST DID MINE...COMP IS FINE..IT AUTOMATICALLY ACOMMADATES FOR IT......BUDDY MACK..

User Avatar

The alternator belt on a 1993 Nissan 300ZX will typically squeal if it has excessive wear or it has become lose. This provides a good opportunity to replace the belt before it complete fails.

User Avatar

The 1993 Nissan Maxima transmission is interchangeable with any 1991 through 1995 Nissan Maxima models. The transmission mounts might be slightly different.

User Avatar

Disconnect the battery, move the coolant resevior for some easy access. Loosen the a/c belt and remove. Underneath the car remove the splash guard covering the alternator. Loosen the belt. Disconnect the plug and ground. Unbolt alternator. Replace in reverse order. Have fun

User Avatar

Its on the passenger side of the car. It comes out of the bottom. There is a small splash guard covering it. The A/C belt has to come off before the alternator belt. Have fun! Have you tried opening the hood?????????

User Avatar

LOOK ON MY BIO PAGE....UNDER MAXIMA INFO...............BUDDY MACK..

User Avatar

Replace the right axle. Get a book on the car at the library and folow the plan to change it .

User Avatar

How do you replace the CV joints on a 1993 Nissan Sentra XE?"

User Avatar

The IAT sensor is installed in the intake air duct

User Avatar

Almost all thermostats are located at the motor where the top radiator hose connects to the motor. Drain the coolant, remove the 2 bolts in the thermostat housing, replace the thermostat, and replace the housing and refill the radiator.

User Avatar

Remove the belt from your 1993 Chevy G 20 alternator. Remove the alternator wiring harness. Remove the retaining bolts from the alternator. Reverse the process to install the new alternator.

User Avatar

Remove the wiring harness from the back of your 1993 VW Jetta alternator. Remove the three alternator retaining bolts. Remove the alternator belt. Reverse the process to install your new alternator.

User Avatar

if the a/c is empty it can hold 1.9 to 2.1 pounds of freon

User Avatar

if its a single overhead cam it has a belt and if its dual it has a chain

User Avatar

To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.