* Disconnect the negative battery cable.If the vehicle is equipped with a delco loc 2 or theftlock audio system make sure to have the activation code before disconnecting the battery. * Remove the drivebelt * Label and detach the wires from the backside of the alternator * Remove the mounting bolts and separate the alternator from the engine
I'm assuming you mean "hotwire"? Don't try it. You will fry the computer.
Open the hood and look straight down on the front of the motor. It is in front of the motor by the fan.
39
Johnson outboards, model RDS-24L, would be a 1962 year model, 40 hp. the boat motor is a 50 hp.
Well, isn't that a happy little question! To figure this out, we need to know how many milliliters are in a liter. Since there are 1000ml in a liter, a 24l can would be 24,000ml. If we divide 24,000ml by 1500ml, we find that you would need 16 buckets to fill a 24l can. Happy painting!
On the oil pan.
0.39-0.43 inches
You didn't say which engine, but, The 24L DOHC engine is located in the top coil pack cover It is a rectangle shape plugin next to the fuel lines. On an 2.2L OHV engine follow the plug wires. It will be underneeth the coil pack. Either way the coil packs are sitting on top of the ICM....
Sounds like a bad starter. same thing happened to a car i was working on and it turned out to be the ground from the batt to the powersterrig pump. went throungh two perfectly good startes thinking there crap when there where fin.
24L/1500mL = 24/1.5 = 16 buckets.
I have not pulled an oil pan on the model, however, most oil pans can be removed by removing the motor mount bolts and raising the engine up rather than pulling it, which is much less work.
try checking your catalyctic converter