Alternators
Ford Ranger
Ford Ranger XL
Ford Ranger XLT

How do you replace the alternator on a 1998 Ford Ranger?

222324

Top Answer
User Avatar
Wiki User
2007-04-28 02:16:45
2007-04-28 02:16:45

Alternator - removal and installation. (1)disconnect the negative cable from the battery (2)remove the air cleaner assembly to gain easier access to the alternator (3)unplug the electrical connectors from the alternator (there are three) and remove the electrical connector bracket, if equipped (4)remove the drive belt by loosening the automatic belt tensioner (use a 3/8th inch drive ratchet and insert into the 3/8th inch square hole on the upper part of the tensioner. rotate counter-clockwise to loosen) (5) remove the three bolts holding the alternator to its mounting bracket (6)installation is the reverse of removal. - Haynes Repair Manual Ford Ranger 1993 - 2005. Good luck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Are there any steps on how to change the alternator on a 1198 ford contour?

User Avatar

The Ford Ranger alternator bolt torque specification is dependent upon the year of the Ford Ranger. In general, the alternator bolt torque specification is 45 pounds.

User Avatar

Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

User Avatar

How do you replace a 2003 Ford Ranger radio

User Avatar

My Ford Ranger is a 1998 4.0 ltr V6.

User Avatar

What is the timing for a 1998 ford ranger 2.5l

User Avatar

loosen the serpretine belt tension and remove the two bolt that hold the alternator

User Avatar

how to replace water pump on 2001 ford ranger

User Avatar

I believe the voltage regulator is on the back of the alternator

User Avatar

how to replace u-joints on 1995 ford ranger 2wd

User Avatar

In the alternator. Have to replace the Alternator.

User Avatar

How to replace alternator on a 2003, Ford F-350, 6.0 ltr.

User Avatar

what is the axle gear ratio for a 1998 ford ranger 4x4 4.0l?

User Avatar

No, the cab was lengthened in the 1998 model year.

User Avatar

need locations of steering column brackets on a 1998 ford ranger

User Avatar

how do i replace a throttle cable on a 1988 ford ranger pickup

User Avatar

steps to replace alternator on 2003 ford d150

User Avatar

what holds the the cigarette lighter in place once it is installed

User Avatar

The voltage regulator is on the back of the alternator on a 1994 Ford Ranger 2.3 liter

User Avatar

how do i replace front wheel bearinbs on 2000 ford ranger 4wd

User Avatar

The wheelbase of the 1998 Ford Ranger Supercab is ( 125.7 inches ) according to the owners manual

User Avatar

Bank 1 is the passenger side of your 4.0 liter V6 in a 1998 Ford Ranger

User Avatar

how do you replace a turn signal flasher on a 1999 ford ranger pickup


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.