To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
From inside the trunk.
Open trunk and remove screws that secure light assembly to car. Pull assembly straight back to remove from car. Remove the dead light and replace with proper new light. Install in reverse order of removal.
how do i remove the brake rotors for a 2003 Toyota tacoma v6 2wd
y
If it is your emergency brake warning light, the switch that warns you that the brake is applied may be out of adjustment.HOWEVER - if it is your brake system warning light - GET IT LOOKED AT ASAP - The vehicle's on-board computer is sensing that there's something wrong with it.
how to replace drive belt 2003 Toyota matrix
replace sensor when pad repacement is done
Your front breaking pads are needed to be repalced, you might have to replace rotors.
take screws out of lense and pull bulb out.
video on how to replace parking brake cable in ford escape 2003
Open the rear hatch and look directly behind the bulb on the inside of the compartment. You will find a small snap-off door, open it. Reach in and twist off the bulb plug to reveal the light assembly. Pull out the bulb and replace with a new same type bulb and replace everything.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.