How do you replace the bulbs in the tail lights of a 1999 Hyundai Sonata?
If you are afraid of breaking something take it to a garage.
What do you do if your tail lights do not work while driving though brake lights work fuses and bulbs are good?
It depends what lights you are talking about, most dash lights are just bulbs. However in the cluster for digital lights and the fog light acessories they are done by LED lights in which you can replace if you know the right voltage. There are a lot of dash lights, so I Repairing Dashboard Lights Take apart the dash (or area where the lights are burned out) and replace the bad bulbs with good ones.
There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.
First off are your dash lights out if so its more likely to be a fuse that you need to replace check your owners manual the dash lights in a corolla are LED lights so its not likely they have burned out. if your looking to change the color of the bulb go to an audio installer for directions on removing your dash panels to get at the bulbs to replace them there's one in…
This is for the Heater/Fan/Cooler lights. To replace the bulbs remove the control knobs by pulling them off, the front panel can be pulled off using a small screwdriver, pry it off on the right side then remove the clear diffuser panel and twist and pull the small bulbs out. There are 2 bulbs for that heater knob control. (bulb # 90069-98004)
look in the users manual for the instructions on replacing bulbs. it's the same because you have to remove the assembly to replace the bulbs there are 2 jack screws , on the top of the assembly, one on each side. remove them and pull the assembly out towards the front of the car. remove the lights put the lights in the new assembly. put the new assembly back in and replace the jack screws…