the camshaft sensor is located above the harmonic balcance on the front of the engine block it is easiest to access this from under neath the car to replace , remove wire harness from sensor remove bolt that holds sensor in block remove sensor.this will pop out of block,may need a small screw driverto get it started replace with new sensor, the attaching bracket will only go on , one way replace bolt reattach wire plug you have now replaced cam sensor
Camshaft sensor is going bad. I've had to replace two now.
The camshaft position sensor is mounted on the front of the 5.9l engine. It is at the top of the timing cover, on the back of the flange.
It is in the distributor, you have to buy a distributor to replace.
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
where is the camshaft sensor on a 2006 dodge ram 5.7 litre
Camshaft position sensor. There is a recall for them i believe. It will cause cutting out and stalling. It happened to ours too. Camshaft position sensor. There is a recall for them i believe. It will cause cutting out and stalling. It happened to ours too.
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
It is behind the starter.
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.
In the distributor
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine