First you un bolt the trans move it back Then unbolt the clutch remove the pressure plate replace it the put the clutch back on put the trans back bolt it and there u go and u have to un bolt the drive shaft first
i went on eBay and bought one for 149$ clutch and pressure plate with alingment tool, but installation might cost you a couple bucks!
there is not adjustment for the clutch, you need to replace it if is bad.
It's a hydraulic clutch ( the clutch fluid reservoir is near the brake master cylinder )
The cost to replace the clutch on a 1993 Toyota Celica will vary depending on labor and part costs. The clutch for the vehicle costs approximately $67.63 in some stores.
The estimated cost for parts and labor to replace the clutch on a 1993 Toyota Camry is between $1,260 and $1,687. This can be higher or lower depending on where a person lives.
Verify that the clutch is working. If there are noises, there is a problem. Disconnect the negative charge. Lift the vehicle up and support it. Support the engine with a hoist. Disconnect clutch linkage. Remove the clutch and replace it.
you will have to remove the transmission. once you have the tranny off you can remove and replace the clutch...if you buy a new clutch specific directions will come with it...too long to write here.
specs on how to replace a heatercore on a 1993 ford explorer
Front wheel bearings on a 4 wheel drive Explorer are not serviceable, replace them.
The fuel tank will have to be removed from the Explorer. The pump is bolted in the top of the tank.
Look in this web site for complete instructions: www.techcapri.com.
Well first of all, if your talking about a manual shift, the clutch is. more or less part of the transmission. Sounds to me like your clutch pad / disk is worn out or you burned it up. Which can happen if you slip the clutch all the time at stop lights / signs. In that case you should probably replace the clutch plate and disk replaced, and have your flywheel resurfaced.