answersLogoWhite

0

behind the rad support there are two tabs directly behind the headlight. pull up the tabs and pull headlight out straight. you well be able to get at bulb to replace it.then put headlight back and push down tabs after bulb is replaced.then you are good to go

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

how do i replace my front running / blinker buld?

need to replace my front lower running / blinker bulb how do i do it


How do you replace a 2001 BMW X5 front blinker?

How do you change a front blinker bulb for a BMW X5 2001?


How do you get parts to replace the front bulb socket for a blinker?

I get everything out of a junk yard


How do you fix turn signals that turn on and do not flash?

AnswerTo fix it do this : say the drivers side blinker goes on and does not flash. Well then you have either the front or rear blinker burned out. Thx KBThere's the possibility of burned bulbs, but if both sides fail to blink, replace the flasher unit.


How do you change drivers side front blinker on a 2001 Mazda Tribute?

its in the owner's manual. usually with pictures.


Chevrolet S10 only driver side front blinker not working?

Replace the bulb.


Why does right front blinker not work on 2000 expedition?

Replace bulb and check socket for ground and Hot


How many transmission mounts on a 2000 Oldsmobile alero?

there are 3 transmission mounts on the car. Drivers side front, drivers side rear, and a center mount as well


How do you remove the front blinker cover on a 2003 Chevy Express van in order to replace the blinker?

You remove the headlight to gain access to the back of the blinker housing, you can reach into the back of it and pull out the light and cable it's attached to. It's a pain.


How do you change the front blinker cover on a Skoda felicia?

To change the front blinker cover on a Skoda Felicia, first, ensure the vehicle is turned off and parked on a level surface. Remove the screws or clips securing the blinker assembly, typically located on the front bumper. Gently pull the assembly out, detach the old cover, and replace it with a new one, ensuring it fits securely. Reassemble the blinker assembly by reversing the removal process and test the blinker to ensure it functions properly.


How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck?

How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck


Where is the master cylinder located on a 2001 oldsmobile alero?

left front firewall on drivers side, just below the brake booster.