What you need to acces is the factory amp/control for the radio which is under the dash right and above the gas pedal. Wire your radio harness and get your antenna adaptor. Unbolt and remove the factory amp and using the harness you unplugged, plug that into your nes harness and plug your new antenna adaptor to the mini gm antenna. remove the center panel between the cluster hump and glove box. pull the wires up from the bottom left of the hole in the dash. Take the new dash kit and put in the cage from your radio, put the a/c vents in the new dash kit, remove the two clips from the factory trim piece and put them on the back bottom edges of the new dash kit to hold in the bottom. Now plug in the harness and antenna, slide the radio in the kit and place the dash kit in the hole, top in first and push the bottom in. TAH-DAH new radio, and replace the speakers while you are at it you should have 4 4"x6" speakers.
Set the original stereo at a 6 degree angle and pull gently.
You can find a stereo wiring diagram for your 1990 Chevy Cheyenne 2500 at most Chevrolet dealerships. The stereo wiring diagram will be in Chevrolet service manuals at your local library.
how do I replace the inside door handle on a 1998 chevy cheyenne?
Remove the decorative stereo retaining cover. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness and the antenna cable.
A 2007 Chevy Avalanche will only have an external factory amplifier if it is equipped with a Bose stereo system. If there is a factory amp included, it will be underneath the center console.
u have to go to the shop and buy it and pay the shop to install it
Could be the factory amp had more power than the aftermarket unit most are around 45-50 watts or so they clam. But I'm sure these are overrated as well.
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
Get a repair book at the library. And you need a wheel puller, a tool.
Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
where is the transmission censor located on a 1997 Chevy cheyenne truck
Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.
replace or repair. It will only get worse.
Go to this site they almost every auto factory wiring diagram for free. www.the12volt.com
Sometimes you have to cut the dash hole bigger. I suggest you take it to aomeone willing to tackle it.
I have a 2002 demo model, and its 60 watts per channel. peak power not rms.
Remove the decorative cover from your 2006 Chevy Express stereo. Remove the stereo retaining screws. The stereo will slide out. Remove the wiring harness and the antenna cable from the back of the stereo.
A Chevy Cheyenne and Silverado are the same its just that they changed the name in Mexico from Silverado to Cheyenne
The wiring of a stereo is connected to the audio inputs. This is standard in a Chevy Blazer and other cars.
If it is the factory radio, then the pin-outs diagram should be stamped into the metal on the radio it-self.
Use a flathead screwdriver to take off the black plastic dash panel that surrounds the stereo and ac. After you get that off then use a socket wrench and unbolt the stock stereo and you'll have it out.
Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.
what are the stereo wire color codes for a 2002 Chevy impala LS
I believe 1998 was the last year for the cheyenne option package.