Do you mean the front wheel bearings??, if so.. you need to take the wheel off take the rotor, caliper/hanger and caliper all off.. crack the bottom ball joint pry the strut around.. there are 4 bolts u need to take out. they are holding the wheel bearing in place.. and then the bearing should come out.. it wont fall out you may have to pry on it to get it out it might be a little rusted in there Hope that helped...
blown brake hose, front passenger side in 1997 chevy malibu?
Did you ever get anywhere on this thread? I'm looking to replace the front bearings and rotors on my 2000 ZR2.
Front or rear bearings? 2 or 4 wheel drive? year of truck?
Depending an where you live and which shop you have do the work about $300.00
2005 Chevy Malibu, shocks in rear, Struts in front.
you can't replace just the front wheel bearings, they are sealed so you have to replace the entire hub assemble and it will cost approximately $130 each side.
There are many dissimilar vehicles vehicles out there called Chevrolet Malibu, and front/rear wheel bearings can be different. Is your Malibu FWD or RWD? If fwd: no. The wheel bearings are ball-in-cage type bearings that are an integral part of the hub-and-bearing assembly which must be replaced as a unit. If rwd: maybe. The front wheel bearings are taper bearings held in place by a nut with cotter pin. The rear rear wheel bearings (axle bearings) are in fact pressed into the axle tube.
How do you replace the front wheel bearings on a nissan frontier 4x4 1999
My 1999 Chevy Malibu has a fuse box under the front hood,
how do you replace rear wheel bearings on nissan pulsar
Wheel bearings? 4X4 ? 4X2?
Possibly front wheel bearings or the front brake caliper's or sticking on. My car is doin the same right now. I'm replacing the wheel bearings and front caliper's,pad's and rotor's.
This is a very hard job without the proper equipment. Not recommended for the novice. It will also depend which bearings you are asking about, front or back. Both equally hard to do.
Should be if undamaged.
If it is 4x4, you have to replace the whole hub
Z71Tahoe-Suburban.com has a number of write ups. Pretty easy job.
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
how do you replace front passenger window switch on a 2000 chev malibu
i have a 2004 Chevy Malibu classic which i think is the same as a 2003. the sizes r 4-6 on the front doors and 6-9 on the back.