0
How do you replace the fuel filter in a 1994 Cadillac Eldorado?
Wiki User
∙ 15y ago
It should be located in-line under the driver side door towards the back if you look under there it is easy to spot then it is just a matter of using wrenches the loosen the bolts i can't remember exactly what size but they are between 13mm and 15mm bolts
also remember that the fuel line remains pressurized even when the engine is off so be prepared to get a alittle gas on you hope this helps
-amatureprofessional
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace Brake pads on a 1994 eldorado?
I need to replace the disc brakes on my 1994 Cadillac eldorado touring coupe? could you supply a diagram of this producure?
What kind of engine oil does a 1994 Cadillac Eldorado take?
10w30
How do you read the codes displayed on a 1994 Cadillac eldorado touring?
what buttons are used to bring up codes on display of 1994 cadillac etc
Why is your car not starting after running out of fuel then refueling on a 1994 Cadillac Fleetwood?
Clogged fuel filter, replace.
How do you change serpentine belt 1994 Cadillac Eldorado?
Serpentine brote change
Can you install a 1994 Cadillac deville transmission 4t80e into your 1994 eldorado Both are 4t80e with a y?
Yes
Bad fuel filter on a 1994 cadillac sedan deville?
Ok, replace it. Located on the frame rail of the car.
What causes the engine overheat light to come on in a 1994 Cadillac eldorado?
The engine is overheating.
How much will it cost for a new radiator on a 1994 Cadillac Eldorado?
You can order it online for about $110.00.
Will 16 inch tires fit 17 inch rims for a 1994 Cadillac ElDorado?
no.
What can you do if your 1994 Cadillac eldorado touring coupe fuel gauge is not operating?
If the fuel gauge is not operating on your 1994 Cadillac Eldorado touring coupe, you might have an issue with the sensor or with the fuse for the fuel gauge. You will need to check your electrical system first.
Where is the map sensor for a 1994 Cadillac eldorado?
In many cases for this generation, your top cover has a total of 12 screws with a torx head on them. Remove those and you will see the sensor to the right. Replace and re-install.
