1. Unbolt the retaining screws and remove the protective shield from the fuel filter.
2. Place a pan under the delivery pipe to catch the dripping fuel and SLOWLY loosen the union bolt to bleed off the fuel pressure. The fuel system is under pressure. Release pressure slowly and contain spillage. Observe "''no smoking/no open flame precautions''.
3. Remove the union bolt and drain the remaining fuel.
4. Disconnect and plug the inlet line.
5. Unbolt and remove the fuel filter.
To install:
When tightening the fuel line bolts to the fuel filter, you must use a torque wrench. The tightening torque is very important, as under or over tightening may cause fuel leakage. Insure that there is no fuel line interference and that there is sufficient space between the fuel lines and other components.
1. Coat the flare unit, union nut and all bolt threads with engine oil.
2. Hand-tighten the inlet line to the fuel filter.
3. Install the fuel filter and then tighten the inlet line nut to 22 ft. lbs. (29 Nm).
4. Reconnect the delivery pipe using new gaskets and then tighten the union bolt to 22 ft. lbs. (29 Nm).
5. Run the engine for a short period and check for any fuel leaks.
6. Install the protective shield.
take it to a garage
you have to unhook the whole filter that looks like a canister then replace it using the new copper gaskets.
How do you replace the fuel filter located on a 1990 Toyota Camry?" 1990 Toyota Camry fuel filter is located under the air intake hose, disconnect one end of the hose from the throttil body and other end from air filter box.And move the hose to the side. Now you could see the fuel filter. You need to use two open end range to disconnect the fuel filter.I believe it is 17 mm, not sure.Don't forget to put a piece of rag under the fuel filter, because you will spill some fuel.
how do i replace a power steering pump in a 1990 toyota camry?
fuel tank
== ==
very carefully
on the air filter housing assy
There is 2 filters. CAUTION!!! Gas line is highly pressurized. One filter is under tank at bottom exit, other filter is under hood. GOOD LUCK!
tool for drive shaft
The engine oil capacity of a 1990 Toyota pickup is 5 quarts. This includes replacing the oil filter which stores a small amount of oil.
I paid $500 to get it replace.