Open the hood, at the top of the lamp assembly are two inverted "L" shaped pins. Rotate each pin 90 degrees and pull straight up. This will allow you to pull the headlight assembly forward. There is a release on the bulb socket, depress this and rotate the socket counter clockwise. When replaceing the bulb, handle it with a clean cloth or gloves. The oil in your skin will cause the bulb to burn out faster, making you go through this process again. .
read the manual
There are two clips on the wall that holds the headlights. Push the clips away and pull the headlight housing out.
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel
how to replace a heater core in a 1997 Chevy blazer
Where is the horn located on a 1993 chevy blazer
It is on the drivers side quarter panel right behind the headlight.
The headlights do not have a fuse, they have a circuit breaker that is built into the headlight switch.
Remove the headlight connector from the back of your 2002 Chevy Monte Carlo headlight. Take hold of the lightbulb, push in and turn at the same time, to remove. Reverse the process to replace the new headlight.
It is located in the gas tank. The tank will have to be dropped in order to replace it.
how do you replace seatbelt retractor on a 2000 chevy blazer
Where is the control module located on the 1983 Chevy blazer
where is the blower motor on a 2001 chevy blazer
Where is the idle speed motor located at on a 1995 chevy blazer?
how do you replace dome light in s10 chey blazer?
low beam headlight bulb type: 9006
Back then the headlight circuit was protected by a circuit breaker that was built into the headlight switch.
The tire jack is located in the rear inside of your Chevy blazer. The jack can be found in a side compartment.
The headlight fuse located on a 1995 Chevy Tahoe is under the hood. It is located in the fuse box on the passenger side.
Check under vehicle follow the fule line from the tank
Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.
more then likely w/ no more info then is provided there is a silver rod on top of the headlight pod you slide to the side then the whole light will come out and you can replace the bulb and reinstall.
the headlight assembly needs to come out in order to replace the bulb.
I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.
It is built into the headlight switch.
Well first of all you need to specify what the problem with it is