Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
How I can replace ignition switch cylinder from Isuzu Rodeo?.
On the column accross from the key lock cylinder
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.
I recenlty got a recall on my ignition switch in my 2000 sunfire and I just took it to the dealer and they did it for free.
The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.
How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
The cylinder should not be worn out on a 99 car unless you were using a very heavy key chain. I would just replace the ignition switch if the cylinder works OK. You also might try some Graphite lube on the cylinder.
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.