answersLogoWhite

0

The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Is there a reset switch for the ignition on a 1989 Dodge colt gt turbo 1.6 liter?

No.


Why is there no fire going to the distributor on my 1992 Plymouth Colt?

Check the ignition coil or the "pick up" located inside the distributor


Where is fuel relay switch on 1990 Plymouth colt?

i have a 91 hatch back mine is located directly below the radio on the floorboard


Where is the starter in a 1993 Plymouth Colt?

The starter on the 1993 Plymouth Colt is mounted on the back side of the engine (by the firewall), and below the intake manifold.


Is there a points distributor that would replace the electronic ignition in a 90 colt 1.4?

No there is no points distributor for that year. Courtesy of the Garage Guru Consultant.


Where is a ignition module located on a 1993 dodge colt?

where is a ignitionmodule in a dodge colt a 1993


What grade of oil does a 1994 Plymouth colt use?

5w30


Where can you find the fuse diagram for a 1994 Plymouth Colt?

Public Library.


What is the Firing sequence 1990 Plymouth Colt?

1-3-4-2


A drivers side headlight assemby for a 1987 Plymouth colt e and cannot find one All the parts house show a sealed beam light and your colt takes a 1004 lamp Thanks?

I need a headlight assembly for 87 Plymouth colt e. drivers side


How do you change the ignition switch on a 92 Mitsubishi Mirage hatchback?

I changed the whole ignition in a 93 colt. I got the replacement from a lancer!The ignition wraps round the steering column and is bolted with sheer away bolts. The bolts are designed to break when originaly tightend (Antitheft). you will have to use a hacksaw blade to cut slits in the top of the bolts that are on the suspect ignition. when slits are deep enough, use a flathead screwdriver to remove them. You will have to get new bolts from your Mitsubishi dealer. when its off the ignition switch is held by a Philips screw, remove and continue with putting the replacement ignition on! hope it helps!!


What causes the distributor not to fire to the spark plugs on a 1993 Plymouth colt?

A faulty ECM!!!