try this site, it has evertine ya need to know .... http://www.wjjeeps.com/lamps/lampsrem.htm
hope it helps
change the headlight switch !
To replace lamps the cluster must be removed.
Most of the cars now have composite lights and the lights have to be revomed to replace the bulbs.
the fuse is blown. they are on the same fuse
why do the back lights stay on when the car is off and the brake release is checked on a 1994 Honda accord
Assuming you mean the instrument cluster lights, consult this link: http://www.lincolnsonline.com/tech/00086.html If you are referring to other lights (radio, switches, etc.) those are not serviceable. You have to replace the unit that's failing.
AnswerCheck the fuse Check the control switch on dash (if any) labeled with a light bulb symbolMy Interior lights worked when I turned them on manually with the roll switch, but when I set the switch to neutral and placed the auto switch to on, so that when the doors were opened the light should come on, they would not.Answer: The little push switch located on the side of the dash when the door is closed its pressed in by the door, when the door is open the switch springs out and the light comes on. If this switch is bad or has a short (jiggle) interior lights wont work when door is open and dash is set to AUTO. Replace!
replace the headlight switch its wore out replace the headlight switch its wore out
could be numerous reasons, such a bad courtesy light switch on either of the 4 doors, a grounded courtesy switch wire, or possibly an entry module fault ( when you push in the lock button, and the interior lights come on ) . Good luck
It really needs to be checked out but it probably is the headlight switch itself that is malfunctioning.
To replace the instrument panel lights in a 1994 Buick Regal, first ensure the vehicle is off and disconnect the negative battery cable for safety. Remove the instrument panel by unscrewing the screws that secure it, then carefully pull it out to access the bulb sockets. Twist the bulb sockets counterclockwise to remove them, replace the old bulbs with new ones, reassemble the panel, and reconnect the battery cable. Finally, test the lights to ensure they are functioning properly.
Remove the cover on the interior by prying then remove the three bolts with a 10 mm ratchet and pull it out.