The Blower Motor Resistor Pack is defective. Replace it.
it needs a blower motor resistor to make the fan settings work.If you replace the Blower MOTOR Resistor it should resolve the problem.
heat not working
How do you replace a fan blower resistor on a vauxal Corsa?
the resistor has melted the variable settings. Replace resistor under passenger dash.
Your wiring is probably messed up, happened to me. Locate the wires from the blower to the controls check them and replace as needed. Assuming no wiring problem check and replace the blower motor resistor.
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
how to replace blower resister on a 325i BMW 2002
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
If you are saying the Blower Motor only works on high, then your problem is a defective Blower Motor Resistor Pack. Replace it.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor
where is the switch resistor on 2003 buick
Replace the HVAC resistor pack, it is defective.
You must remove the glove compartment door to access the blower motor. On top of the blower motor will be wires connecting to the top. Release the connecter and let it dangle. Then using a screwdriver, remove the blower resistor on top, where the wires connected, and replace with a new resistor.
Defective blower motor resistor pack.
check the blower motor resistor
Does your blower work on ANY settings? If it works in the HIGH setting only it's a good chance that the ressistor is bad. Don't worry they are easy to replace and fairly inexpensive.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
To test the blower motor resistor, unplug the resistor connector. Each blower motor switch input terminal on the resistor must have continuity to the resistor output terminal, which is connected to the circuit going to the blower motor. If the blower motor resistor continuity does not check OK, replace the faulty resistor.You need a multimeter to test the resistor block and there should be continuity between all terminals.