One of the Gurus at our enthusiasts forum will help you with that one!
www.trailvoy.com
The light assy has to be removed to take the bulbs out.
We can replace it easily
you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.
how do you replace side marker light on 2008 chevy trailblazer
how do you remove dome light lens on 2008 trailblazer
If you brake lights are not working on your trailblazer it could be due to a number of reasons. Your fuse could be blown, or your light may no longer work.
To replace the middle high brake light on a 1999 Lexus GS300, first, open the trunk and locate the plastic cover that conceals the brake light assembly. Carefully remove the cover by unscrewing or unclipping it. Then, disconnect the wiring harness from the old brake light, remove the old light bulb from its socket, and replace it with a new one. Finally, reconnect the wiring harness, reattach the cover, and test the light to ensure it works properly.
As far as I know, they are not on the same fuse/relay.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
On a 2003 Chevrolet TrailBlazer, the brake light switch is typically located above the brake pedal, mounted on the brake pedal assembly. To access it, you may need to remove the lower dashboard cover or panel. The switch is usually a small component that activates the brake lights when the pedal is pressed.
How to replace a brake light on a nissan Tiida hatch back.
You have to open the rear hatch like you would to replace the reg. brake lights. Screws should be accessible once hatch is fully open.