Start by removing the trim panel form the interior side of the door. To do this you will need to remove the window crank or the electric window switch. The crank is held on by a retainer spring clip that pinches around the base of the crank. Push back the panel, grab the loop end on the clip and pull it out. The crank will then slide off. The panel is held on with a screw at the pull handle & about 8 panel retainers. Recommend using a special tool for removing these. The tool is available at most auto parts stores. Slip tool between the panel and the door and pry the retainers loose then remove panel and the plastic dust barrier behind it. The window pane is held in place by 2-12mm headed bolts. You will need to raise/lower the window to reach them. You may also need to remove linkage for the door to attain better access to the window. Install in reverse order
Nope, different body styles
Replace the window regulator
Driver window is out of alignment on a 95 Nissan 240sx? what do i do
ask the mechanic from the Nissan company
you can get it from a junkyard for like 5 bucks, any 240sx window motor will work. dont go to a dealer because I went and they tried to charge $100.
loosen the manual tensioners and the alt bracket.
i would like to know as well
The Nissan 240SX was brought to America in 1989.
Nissan 240sx
Had the same problem. Nissan covers this for the life of the vehicle, go to the dealer and let them replace the vehicle restraint system.
The fuel filter is located under the hood on the back firewall, passenger side.
I do believe it is on the top of the passenger side valve cover. That was where it was located in the 1991 240SX. You want to make sure the car is turned off before you begin looking for it.