0
What else can I help you with?
Do you have to drop the tank on your 1986 oldsmobile cutlass ciera to replace the fuel pump?
Yes, you do.
Where is the fuel pump relay on a 1986 cutlass ciera?
in the dash panel
Where is 1986 Oldsmobile cutlass ciera water pump at?
It varies by engine.
Where is thermostat on 1986 cutlass ciera?
Should be in a removable housing at the engine end of the upper radiator hose
Where is carburetor on a 1986 cutlass ciera?
I do not think there is one. I belive its fuel injected. I have a 88 and its fule injected.
Will a 1986 Oldsmobile 98 3.8 liter motor fit in a 1993 Oldsmobile cutlass ciera s?
Yes
What is the firing order for a 1986 Oldmobile Cutlass Ciera 2.8 V6 if it is not 1-2-3-4-5-6?
The firing order for a 1986 Oldsmobile Cutlass Ciera 2.8 V6 is 1, 2, 3, 4, 5, 6. The number one cylinder is on the front left as you face the engine compartment.
Where are the motor mounts on a 1986 cutlass ciera?
On a 1986 Cutlass Ciera, the motor mounts are located on either side of the engine block, securing the engine to the frame of the vehicle. Typically, there are two main mounts: one on the driver's side and one on the passenger's side. Additionally, there may be a rear mount supporting the engine at the back. These mounts help absorb vibrations and maintain engine alignment.
Where is the highbeam switch on a 1986 4-door Cutlass Ciera?
On the turn indicator. Pull the turn indicator toward you until you hear it "click", about 1/4", then release.
Where are the sensors located that run the cooling fan on a 1986 cutlass ciera?
In a 1986 Cutlass Ciera, the cooling fan is typically controlled by a temperature sensor located in the engine coolant passage or near the thermostat housing. This sensor monitors the engine temperature and signals the fan to activate when the temperature exceeds a certain threshold. Additionally, there may be a relay in the electrical system that controls the power to the fan based on the sensor's input.
What would cause a 1986 cutlass supreme to lose spark?
Replace ignition module (under the distributor cap)
Installing a water pump Oldsmobile cutlass ciera 1986?
To install a water pump on a 1986 Oldsmobile Cutlass Ciera, first, disconnect the battery and drain the coolant. Remove the serpentine belt, then detach any components that obstruct access to the water pump, such as the alternator or power steering pump. Unscrew the old water pump from the engine block, clean the mounting surface, and install the new pump with a fresh gasket. Finally, reassemble everything, refill the coolant, and reconnect the battery.
