Want this question answered?
how do you replace the drive belts on an 1974 mercedes 230
That is a bearing in the centre of a crankshaft or drive shaft.
You must remove the rear drive shaft section and then remove the support.
Please answer the question Please answer the question
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
Deadly, get it carefully to where you can work on it and replace it.
you don't, you have to replace the whole drive shaft.
if your refering to the center carrier bearing on drive shaft , it is easy to do, get the new carrier bearing before you begin , two versions 6.5 inch and 7 inch. If your refering to the rear end carrier bearing, completely different deal. Which bearing ? axle or main pinion gear bearing ? let me know i have a complete rear end looking for a home out of a 2000 kia sportage.
no
Center bearing should be replaceable after removing driveshaft
1: disconnect the drive shaft from the rear axle. 2: disconnect the front shaft from the transmission (tedious and you need the correct size tool). 3: disassemble the front shaft from the main shaft by pulling them apart from the center or in front of the support and drop the main shaft. 5: remove bolts holding the support and drop and remove the front shaft shaft with the support still connected. 6: remove and replace the support with a wheel puller. 7: replace support with new part. 8: reassemble in reverse. CDARCO