0
You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the PCV valve on a 1996 Buick Park Avenue and how do you replace it?
It is in the intake behind the throtle body. Simply pull it out and replace it.
Where Is The Low Pressure Side Valve On 1996 Saturn SC1?
Larger hose from a/c compressor may be near the drier on the passenger side firewall
Where is the egr valve on a 1996 grand voyager se 3.3liter?
The EGR valve for a 1996 Grand Voyager is on the side of the engine. It is mounted just above alternator.
Where do you find the PVC valve on your 1996 88 Oldsmobile?
Generally you will find a PCV valve somewhere on one of the valve covers, with a hose the connects to it.
Will a sunroof motor out of a 97 Saturn. Fit in a 98 Saturn SL2?
It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55
Picture of theEGR valve in a 1996 Saturn?
see saturnfans.com
What is wrong when you have oil inside the spark plug guides on a 1996 Saturn?
There could mean that the rings on the pistons are worn. Oil on the top of the plugs means the valve cover, or tube seals have failed.
Why would a 1996 Saturn SL1 be blowing smoke after first starting It will be fine once into 3rd and after that?
Valve guides or seals could be worn allowing oil to build up and be sucked in to combustion chamber
Cant figure out if your 1996 jaguar van den plas has coil gaskets or valve cover spark plug seals?
Jaguars have plug seals.
How do you replace a EGR in a 1996 Saturn SL1?
The EGR valve is located on the drivers side of the head, just above the transmission bell housing. Remove the electrical and vacuum connections, then remove the two bolts that hold the EGR valve to the head. Use a NEW gasket when replacing the EGR valve.
Can you replace a 96 Saturn engine with a 92 Saturn engine?
YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE
Is it recommended to replace rear axle seals but not the bearings on a 1996 Chevy S-10 4wd?
It would be recommended to replace the rear axle bearings and axles when they are worn/bad. If the bearings and axles are okay, just replace the seals.
Valve cover gasket on a 1996 Saturn twin-cam sl2?
.....what about it? There is one. Dealer has premolded ones also
Intermittent starting 1996 Saturn?
Solenoid going bad remove and replace starter assembly.
Where is fuel pump in a 1996 Saturn?
Inside the fuel tank.Removal of the tank is necessary to replace the pump.
How do you replace 1996 Chevy lumina egr valve?
remove the 2 bolts andharness
Where is the PCV valve on a 1996 Buick Park Avenue and how do you replace it?
It is in the intake behind the throtle body. Simply pull it out and replace it.
