0
What else can I help you with?
How do I replace a fuze on my Mazda 1997 truck?
On a 1991 Mazda B2500, there are 3 fuses on the passenger side under the hood ... near the rear and on the side. The two 30 Amp fuses can be pulled out from the top. The 80 Amp main fuse is bolted in on both sides. A small screwdriver will open up access to these bolts.
If the battery goes bad you replace the battery and get no response from a 2000 Mazda Millenia what do you do?
check the main fusible link
How do you replace the main 100a amp fuse on a 1996 Mazda 626 4-cylinder?
Mazda main fuse is bolted in with two M10 bolts. I know because I destroyed mine while trying to remove it. You will need a good socket set with a universal joint to remove it.
Do you pull the trans to replace rear main seal in 1991 Chevy 350?
Yes, That would be the easiest thing 2 do.
How do you replace a flexplate on a 1991 Chevrolet caprice?
Remove the transmission and starter. Unbolt the flexplate from the crank. While you're at it, replace the rear main seal. Replace the flexplate and torque bolts to manufacturer's specs.
How do you replace the main fuse on a 2006 Mazda 6?
To replace the main fuse on a 2006 Mazda 6, first, locate the fuse box, which is typically found under the dashboard or near the driver's side. Use a fuse puller or pliers to carefully remove the blown fuse, identified by a broken metal link inside it. Replace it with a new fuse of the same amperage, ensuring it is securely seated. Finally, test the electrical components to confirm the replacement was successful.
How do you remove main relay on 2007 Mazda 6?
To remove the main relay on a 2007 Mazda 6, first locate the relay box under the dashboard on the driver's side. Open the cover and identify the main relay, which is typically marked in the diagram on the lid. Carefully pull the relay straight out from its socket, ensuring not to damage any wiring. Once removed, you can replace it with a new relay if needed.
How do you change the main fuse in a 2003 Mazda Protege?
help
How do you replace the rod bearings in a 2003 Mazda 6?
To replace the rod bearings in a 2003 Mazda 6, first ensure the engine is cool and disconnect the battery. Then, remove the oil pan and crankshaft main bearings by unbolting the connecting rods from the crankshaft. Carefully replace the old rod bearings with new ones, ensuring proper alignment and lubrication, and then reassemble the components, including the oil pan and battery. Always consult the service manual for specific torque specifications and procedures.
Where is the dome light CPU on a Mazda 626?
The CPU for a dome light on a Mazda 626, and most other Mazda vehicles, is located near the main fuse box. This is found under the hood.
My 1991 Honda Accord does not turn over i cleaned the fuel injector and sometimes it starts and sometimes it does not?
If the injectors on a 1991 Honda Accord are working well than proceed to check the main relay and fuel filter. Replace the components if they are worn and check the engine with a diagnostic test.
How do you replace the starter motor on a 1991 Mazda rx7?
Place car safely on stands or ramps Starter is attached to the gearbox under car Disconnect battery Undo main power cable from front of starter Unplug solenoid wire from front too (thinner cable) Undo two mounting bolts Remove starter (old cliche) lol now installation is reversal of removal process Hope this helps...
