pull forward on the small side handle wich looks like a wrench at the same time pull seat forward pop goes the weasel
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
The rear seat does not come out. The middle seat is removable, after which you can slide the rear one up.
No such option was available.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
How do you remove the driver s seat from a1997 mercury villager
if it is equipped from factory it is mounted by the rear controls for the radio behind drivers seat
To remove the rear seat of a 1997 Mercury Villager minivan, start by locating the release levers or bolts at the base of the seat. If there are bolts, use a socket wrench to unscrew them. For seats with release levers, pull the lever while lifting the seat to disengage it from the mounting brackets. Once released, carefully lift the seat out of the vehicle.
The rear seat (3 person slider) is not designed to be removed by the end-user. However, this site has a good procedure from the shop manual for removing the rear bench seat. http://home.earthlink.net/~vqfaq/
To replace the motor on the power passenger front seat of a Mercury Villager, first, disconnect the vehicle battery to ensure safety. Remove the seat from the vehicle by unbolting it from the floor and carefully disconnecting any electrical connectors. Access the motor by removing the seat cover or base, depending on the design. Finally, replace the old motor with the new one, reassemble the seat, and reinstall it in the vehicle.
no they wont the safest place for a child is in the rear seat until they are 4 ft 2 in tall
How can remove the rear seat on a 1990 mercury sable