You hold the tensioner arm out in the loose position with a ratchet. There's a square hole in it for that. Then the belt will be loose and you just work it out. There's a routing diagram in the engine bay.
You hold the tensioner arm out in the loose position with a ratchet. There's a square hole in it for that. Then the belt will be loose and you just work it out. There's a routing diagram in the engine bay.
Follow the route of the serpentine belt and you will find the pump as it drives the pump.
It's run by the same serpentine belt that runs the AC and alternator. The water pump is on the other end of the engine. Changing a serpentine belt is relatively easy. The tensioner pully must be held in the loose position with a 3/8" ratchet and the belt can be yanked out. Follow the diagram on the sticker in the engine bay to install the new one.
The Mazda Mpv 2000 timing chain
The 2.5 litre V6 engine in a 2000 Mazda MPV has timing CHAINS
nope, chain. 2 of them.
Replace the belt every 60,000 miles. Warning: This is an interference engine.
In the 2003 Mazda MPV, the alternator is typically located on the front of the engine, near the top. It is mounted to the engine block and can be accessed from the engine bay. To replace or service the alternator, you may need to remove the serpentine belt and possibly other components for better access. Always refer to the vehicle's service manual for specific instructions and diagrams.
2001 Mazda MPV does not have a timing belt, it has two timing chains.
What is the cost to replace the head gasket on a Mazda MPV?
where is the position of the start relay in a the 2000 mazda mpv
time as putting the chains of distribution of a 2000 mazda mpv