Loosen the tensioner using a 3/8" drive, and off she comes. Follow the diagram on the passenger side strut tower to make sure you install the new belt correctly
The Haynes Repair Manuals would have a diagram of the serpentine belt on a 94 Mercury Cougar XR7. You can find the manual at your local library, book store, or most auto parts stores.
To change the serpentine belt on a 1988 Mercury Cougar, first take a picture of how the old belt is put on. Then, loosen the nut on the tension pulley and remove the old belt. Use the picture to route the serpentine belt in the same pattern as before. Tighten up the nut on the tension pulley.
To replace the hinge on a 95 Mercury Cougar, remove the bolts holding the hinge in place. Find a replacement hinge from the manufacturer and install it using the right hardware.
You have to release your tensioners in order to release your serpentine belt. When you put the belt back on you have to follow the diagram on the hood of your car.
In the belt book at most autoparts stores have a diagram section for serpentine belt routing.
If the lightbulb itself is burnt out on a 1991 Mercury Cougar then just replace the light. If it is the wiring that is the problem then find the burnt wires and cut them. Replace them with new wiring.
What is the motor size? Run1
Mercury Cougar was created in 1967.
Check local library for service manuals
You can replace the alternator on your 1989 Mercury Cougar by removing the alternator belt. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
If you have the 99 -02 Cougar replace the TPS (throttle positioning sensor) on the throttle body.
fireing order 1998 mercury cougar
Where is speed censor on mercury cougar
how do you remove the headliner from a 1999 mercury cougar
remove dash replace bulb(instrument cluster)
Assuming you mean Mercury Cougar, a new 1983 Mercury Cougar sold for $9800.
The fuel pump on a mercury cougar is in the fuel tank. You are going to have to remove the fuel tank, take the lock ring off of the tank, and then pull the pump assembly out.