remove the door panel
You have to remove the door panel, after that you will be able to replace the speaker.
need to replace door speaker on 2003 Chevrolet Tahoe
6 1/2" and a small tweeter in the upper door that you will not be able to replace with the same size I used the old on as a mount for a 1" tweeter and put in component speaker system in both front doors 6 1/2" and a small tweeter in the upper door that you will not be able to replace with the same size I used the old on as a mount for a 1" tweeter and put in component speaker system in both front doors
Pull off the door panel, unscrew the stock/old 6.5 inch speaker, disconnect the speaker wiring and connect the new speaker. Screw the speaker in the hole in the door and replace the door panel.
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
just take the door card off and unscrew the speaker!
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
You need to remove the Interior door panel. From there you can gain access to the speaker and replace it as needed.
You don't need to remove front door panels, the speaker grills come out.
rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker
Yes, the door panel needs to come off to replace the speaker.
Yes, the Speaker is in the door.
For the front door speakers in a 1997 Honda Civic, the left front speaker wire (+) is blue and the left front speaker wire (-) is gray/black. For the right side, the front speaker wire (+) is red/green, and the right front speaker wire (-) is brown/black.
take the door panel off to expose speaker
how do you replace front door actuator for 93 ford tempo
I had to replace the ones in my 1997 Sebring. Using a tool such as a flat head screwdriver detach the plastic cover that is over the door speaker. Remove the screws that are holding the speaker to the door. Pull the speaker out enough to detach the plastic clip that connects the wiring to the speaker. Installing the door speaker is the reverse of removing the speakers.
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
there are two options one speaker grill in front door = 4" X 6" oval two speaker grills in front door = 5 1/4" round this is as per crutchfield audios website.
You don't have to pull the door panel off... the speaker grille snaps in place. Use a small screwdriver to carefully pry the grille from the panel
6x8 front 6x8rear
4 " x 6" speaker
Should be same as 2001 setup where you have to remove interior door skin to acess speakers, and the 2001 had 4"x6" ovals in doors.
Remove the speaker covers from your 1997 Mercury. Remove the door speaker retaining screws. Remove the door speaker wiring harness. Reverse the process to install your new door speakers.
Remove the door trim panelRemove the speaker mounting screwsPull out the speaker,disconnect the electrical connector from the speaker and remove the speakerInstallation is reverse of removal