When you have purchased your new spark plug wires just lay them flat on the ground or on a table. Remove the old wires one by one. As you remove one wire, measure it up with the new wire and do this for all of the other wires. MAke sure the wires are firmly placed on the coil.
The 2002 Honda Civic EX engine uses coil-on-plug. There are no sparkplug wires.
yes they will
check spark plugs, and spark wires, they may be cracked or dirty you may also need to replace your battery check spark plugs, and spark wires, they may be cracked or dirty you may also need to replace your battery
check the gappings of your spark plugs, it must be uniform.
The distributor wiring order for a 1996 Honda Civic is 1-3-4-2. The distributor will be have the wires in the clockwise position starting a 1.
follow spark plug wires back to other end & that is your coil
All of the spark plug wires go to the distributor. Just follow the wires and you will see the distributor.
OEM are the best spark plug wires for the Honda cbr. These spark plug wires can be found at the local Honda dealership.
It will have a black cap on it with 4 wires coming out and each wire going to a spark plug. Follow the wires from the spark plugs backward and you will find the distributor.
you really cant find it? the spark plug wires only come off of it! back of the cylinder head!
Likely Culprits: Bad Coil. Bad Ignition Control Module. Great Resources:
The ignition coil on a 1998 Honda Civic LX is located under the distributor cap. The distributor is on the passenger side of the motor and has wires running from it to each spark plug. it is usually plastic.
what are the wires to power up the ecu on a 1994 Honda civic si
Many reasons, but here's a few: -spark plugs/wires -fuel pump -timing -battery -starter -injectors
Tail light wires.
To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.
Under the spark plug wires in the cylinder head, on top of the engine.
The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.
follow all the spark plug wires
Like This <img src="http://img503.imageshack.us/img503/2452/sparkplugwiringlayoutcb0.a1964b0a00.jpg" border="0">
It is in the front of the block between where the second and third spark plug wires connect with the engine. It took me a while to find it myself.
Not really the only parts that are interchangeable are the basics like oil filers, spark plugs,and wires. Different sized cars
To replace spark plug wires on a 3300 Oldsmobile engine, open the hood and remove the wires from the end of the engine. The number of spark plug wires most often corresponds to the number of cylinders your engine has.
remove one at a time . take one off and replace with the new one and so on and so forth until you replaced them all
Disconnect the battery, remove the spark plugs wires and boots and remove the spark plugs. Put in the spark plugs, replace the spark plug wires and boots, and connect the battery.